Above is a picture of our windage adjustable service rifle front sight base. As you can see, there are set screws on both sides of the sight. When you receive your rifle the sights are not going to be aligned as you would like them to be, please follow these simple steps to adjust your sights.
This is most conveniently done when you break in your upper.
You will need:
 | 5/64 allen wrench |
| brake cleaner or other degreaser that dries quickly |
| small bottle of loctite of your choice |
| plenty of ammo to test alignment |
1. Make sure that your rear sight is centered.
2. Slightly and evenly loosen the set screws on the side that your weapon is firing to. (VERY slightly.)
3. Gently tighten the opposing set screws evenly.
You may need to repeat steps 2 and 3 several times until you get your front sight right were you want it.
4. Once you have your front sight base aligned, tighten all four set screws evenly and very tight.
You will want to check the alignment one more time at this point.
5. Clean front base and apply a few drops of loctite around the barrel at the front base.
6. After allowing the loctite to dry for at least 10-15 minutes, liberally apply a rust preventive to the area.
Home / Price List / Contact Us
(850) 579-1208